RepStrap

The first step in 3D printing is the hardest one, because you are starting from the position zero. Lack of experience and tools make it really difficult.Almost all parts you have to made manually, it consume a lot of time. Take a look how it could looks like, take a look on the beginning of  PrinterZero.


Step 0
Body made of alloy M6 Screews, polyurethane resin and little bit of MDF plates.



Step 1
Extruder consist of polyurethane resin, springs, 608 bearings, and screws.
It takes a lot of time  to design it, build and run. GPS is very talented, so finally brings it up.



Step 2
Hotend  - PTFE rood, Alloy, Resistor, termistor, copper rood and again GPS skills



Step 3
Stepper motors 4 x  used Nema23 0,6 Nm


Step 4
Electronics - Home made Mainboard and Stepper motor drivers

 

Step 5
PrinterZero - Put all parts together, spent many hours on bring-up, fine tunning and finally ... you will see what happen in the next post.